Tub Bottom Restorer Mat

Allow time for videos to download before viewing, review written instructions while waiting for videos

1

STEP-1

SURFACE PREPARATION

THE ENTIRE INSIDE OF THE TUB MUST BE CLEANED THOROUGHLY

NOT JUST THE BOTTOM

Clean Tub Inside Thoroughly

Remove ALL Dirt,  Soap Film and Body Oils!

2

RINSE TUB THOROUGHLY

DO NOT USE SHOWER HEAD TO RINSE TUB

USE A LARGE CUP TO RINSE TUB

Shower head will get water on walls

 CAUTION: If the walls get wet you will need to be wiped them dry.

WARNING: The Star Fiber towel will pick up body oils etc from the un-cleaned walls, and contaminate the clean part o the tub when drying it.

IMPORTANT: After rinsing the tub, it MUST be scrubbed a SECOND TIME to insure it is perfectly clean! Any soap film, hair rinse wax or body oil left on the tub surface will cause the mat to peel later.

3

AFTER TUB HAS BEEN THOROUGHLY RINSED

1. CLOSE DRAIN OUTLET

2. RUN 6" OF HOT WATER INTO TUB

CLOSE DRAIN OUTLET TO PREVENT LOSS OF WATER

4

ALLOW HOT WATER TO  STAY IN TUB A MINIMUM OF 5 MINUTES

Hot water will speed the drying of the tub. The warm surface will eliminate any condensation forming on surface. The heated surface will create a better bond with the mats adhesive backing.

5

DRY TUB THOROUGHLY WITH STAR FIBER TACK CLOTH

If necessary use a second DRY tack cloth to remove any residual moisture

SURFACE MUST BE DRY!