Porcelain Tub Restoration
|
1 SLIP-GRIP All chips or areas worn through to metal must be repaired before applying Slip-Grip
REPAIRING WORN or DAMAGES TUB BOTTOMS
KF-43 Bottom Restorer Filler Mixing KF-43 and Hardener
2 APPLYING KF-43 OVER DAMAGED, AREAS WORN TO METAL The smoother the application of KF-43 the less sanding required after it hardens KF-43 turns a light green when activated and turns white when hardened. Apply KF-43 With Even Thin Coats 3 CHIP FILLERS REQUIRE HEATING WITH HEAT GUN WARMING AREA BEFORE AND AFTER APPLYING FILLER HELPS ACTIVATE IT FOR QUICK HARDENING KF-43 FILLER BECOMES WHITE WHEN HARD.
4 SANDING CHIP FILLER TO CONTOUR "HAND SANDING" KF-43 MUST BE HARD BEFORE SANDING
5A "OPTIONAL" SANDING CHIP FILLER TO CONTOUR "POWER SANDING"
5B "STAIN-BLASTER™" Multi Tool Can be use for Sanding, Scrubbing, Stain Removal and Polishing
6 TACK CLOTH DUST REMOVAL Dust Removal is Essential
7
10. See number 10 on instruction sheet.
SLIP GRIP BOTTOM Templates Make Perfect Corners
8A TRIM AROUND TEMPLATE WITH NEW RAZOR BLADE AFTER TRIMMING, FLIP TEMPLATE OVER FOR OTHER SIDE OF DRAIN
8B OPPOSITE SIDE OF DRAIN OUTLET TRIM TAPE AROUND TEMPLATE CAREFULLY WITH NEW RAZOR BLADE
9 USE APPROPRIATE TEMPLATES
DEPENDING ON THE SHAPE OF EACH TUBS BOTTOM (SQUARE, OVAL ETC.) Most Porcelain on steel tubs are rather square while porcelain on cast iron tubs are rounded at the back end
10 DRAIN WRAP or FULL BOTTOM
USE FULL BOTTOM WHEN MAKING REPAIRS AROUND DRAIN OUTLET WHEN MAKING REPAIRS AROUND DRAIN OUTLET COVER ENTIRE BOTTOM
11 COVER THE DRAIN OUTLET WITH TAPE FOLDING FIRST PIECE OF TAPE WITH A HANDLE MAKES REMOVING IT EASIER WHEN FINISHED
12 OPTIONAL PROTECTION
Small specks (splatters) from roller appear on side walls if ROLLER is moved to fast or rolled from front to back wall of tub while spreading the material evenly. Moving roller slowly from end to end of tub will prevent or minimize minute splatters on side walls and not require paper.
13
12. See # 12 on instruction sheet. TACK CLOTH
14 SLIP-GRIP
15 APPLICATION IMPORTANT: SLIP GRIP MUST BE MIXED WHEN YOU START THE TUB PREPARATION TO INSURE IT IS MIXED AND SETS (SWEATS IN) A MINIMUM OF 30 MINUTES BEFORE APPLICATION
16 11. See # 11 on instruction sheet. ALLOW TO DRY WITH FAN BLOWING UNTIL DRY TO TOUCH
17 WHEN DRY TO TOUCH REMOVE TAPE AND PAPER
AFTER REMOVING PAPER AND TAPE PROCEED TO STEP-2
© SPR Product Sales 2012 |