SPR EZ-Vent Fume Removal

 

Allow time for videos to download before viewing, review written instructions while waiting for videos

 

  1. Place suction end of EZ-Vent hose on the floor near your work area.

  2. Most fumes are heavier than air and fall to the floor, EZ-Vent easily carries them away.

  3. Place the discharge end of hose out of a window or door away from the work area.

  4. Place the discharge end as far away from your work areas as possible.

  5. Leave bathroom door open, place suction end of hose near tub on floor.

  6. Do NOT run discharge end of hose out of bathroom window where you are working.

  7. In most cases there is not enough room in a bathroom for the entire hose.

  8. With the bathroom door open and EZ-Vent set up as described above, properly discharging out of an outside door or window in a nearby bedroom etc. there will be no noticeable fumes or dust going out of the open bathroom door into the house.

 

Low to Virtually NO Fumes

But to be on the safe side we recommend

 

EZ-Vent

50' L  X  10' D 

 

 

Moves 665 Cu Ft of air per minute

Removes fumes from work area.  

Clean fresh air

is very important for health

 

This is a must

when any kind of fume is present!

50' L  X  10' D 

 

110 VAC operation  

 

             

Suction Just Inside Bathroom Out of Bathroom Door Way
Across The Room

Discharg

Through Outside Door or Window

 

From work area hose reaches up to 50 foot away to exit fumes

For extra long runs use two EZ Vents connected together

 

                 Close Page