Porcelain Tub Restoration

STEP-3

RESTORING THE GLOSS

Follow written Instructions closely

1

BEFORE APPLYING STEP-3

USE T-1 DETECTOR TO FIND

THE AREAS REQUIRING ATTENTION

Turn off ALL other lights in room to make the inspection for best results!

2

DO NOT RINSE APPLICATOR PAD,

CONTINUE TO USE SAME PAD TO APPLY STEP-3

1. Apply MEASURED amount of Step-3 to applicator pad

2. Apply Step-3 ONLY to areas previously treated with Step-2

3. Apply with long even strokes

4. Overlap each stroke with the last one

3

DRY EACH COAT OF STEP-3 WITH A FAN

CAUTION: Each coat must be dry to touch before applying the next coat or the applicator pad will smear the pervious coat making the finish dull and rough.

4

USE DETECTION LIGHT BETWEEN COATS

THERE WILL BE A NOTICEABLE DIFFERENCE IN THE GLOSS

AFTER EACH COAT OF STEP-3

5

USE WHITE PAD WITH VERY LIGHTLY BETWEEN COATS

Lightly wipe all treated surfaces to insure any trash, lint etc are removed

White pad loosens any trash that might contaminate surface causing a rough finish

6

USE TACK CLOTH BETWEEN COATS

Tack cloth removes any trash loosened by the white pad

7

APPLY EACH COAT AT 90° ANGLE TO LAST COAT

Cross hatch coats eliminates missed areas

8

FINAL COAT OF STEP-3

IMPORTANT:

DO NOT USE FAN OR HEAT GUN

TO DRY FINAL COAT

MOVING AIR WILL "KILL" THE GLOSS!

Allow surface to dry naturally

When dry to touch fan or heat gun can be used for further drying

before applying Step - 4

HOW MANY COATS SHOULD I APPLY?

When all treated areas have a wet glossy look like the glossy untreated areas

PROCEED TO STEP- 4

 Close Page

 © SPR Product Sales 2012